Ready Mixed, Crushed Stone and Sand and Gravel Non-Storm
Water Discharges Quick Reference Guide
July 2009
Office of Compliance
Office of Enforcement and Compliance Assurance
U.S. Environmental Protection Agency
1200 Pennsylvania Avenue, NW (MC 2221-A)
Washington, D.C. 20460
http://www.epa.gov/compliance/assistance/sectors/readymix-aggregate.html
-------
Ready Mixed, Crushed Stone and Sand and Gravel Non-Storm Water
Discharges Quick Reference Guide
The information included in this quick reference guide was extracted from the
2008 Multi Sector General Permit (MSGP)for industrial storm water permit
holders. This information is intended to provide a guide for the non-stormwater
discharges information detailed in the MSGP. All facilities under an industrial
stormwater MSGP or a National Pollution Discharge Elimination System permit
must refer to their respective permits for their specific facilities' stormwater
requirements.
Non-Storm Water Discharges
STORM WATER DISCHARGE
Any water runoff, snow melt runoff, surface runoff, or drainage that comes into contact
with industrial or commercial operations/activities and enters the waters of the United
States or a municipal separate storm sewer system.
NON-STORM WATER DISCHARGE & LIMIATAION OF COVERAGE
A non-storm water discharge is any discharge that is not of rain or snow melt origin, but
is generally water or water-borne. For example: a floor drain or sink drain that is not
connected to the local treatment plant but instead flows directly to the waters of the
United States (including groundwater). Non-storm water discharges are not allowed
under the MSGP unless they fall under one of the eleven (11) allowable non-storm water
discharges (described below). If the non-storm water discharge occurs without a separate
permit, the owner/operator will be in violation of the Clean Water Act.
The MSGP identifies some sectors as having "limitation on coverage" which in most
cases is referring to discharges that are subject to other guidelines and in need of a
separate permit (refer to the section below "not authorized for coverage under the
MSGP"). Limitations on coverage are listed below for common port sectors.
NEED TO CERITIFY THERE ARE NO NON-STORM WATER DISCHARGERS
As the owner/operator of your facility, you need to certify that there are no non-storm
water discharges except those allowable non-storm water discharges identified below. To
do so, simply conduct a walk-through of your property during a dry day (e.g. a dry spell
of no rain for at least a week) and check for dry weather flows. Identify any dry weather
flows by documenting how you made the determination, the type of discharge and
location, date, and time and pollutant source if known. Any discharge other than the 11
listed below are considered unauthorized. All unauthorized dry weather discharges must
be eliminated and records must be kept to indicate actions are taken to prevent them.
Your Storm Water Pollution Prevention Plan (SWPPP) should include this discussion and
actions taken.
ALLOWABLE NON-STORM WATER DISCHARGES
-------
Unless otherwise specified for the specific sector, as a permit holder, you are allowed to
discharge to the waters of the United States or a municipal separate storm sewer system
the following non-storm water activities:
1. Fire fighting activities
2. Fire hydrant flushing
3. Potable water, including water line flushing
4. Uncontaminated air conditioning or compressor condensate
5. Irrigation drainage
6. Landscape watering provided all pesticides, herbicides, and fertilizer have been
applied in accordance with manufacturer's instructions
7. Pavement wash waters where no detergents are used and no spills or leaks of
toxic or hazardous materials have occurred (unless all spills have been
removed)
8. Routine external building wash down which does not use detergents
9. Uncontaminated ground water or spring water
10. Foundation or footing drains where flows are not contaminated with process
materials
11. Incidental windblown mist from cooling towers that collects on rooftops or
adjacent portions of facility. Not intentional discharges.
If any of these eleven (11) are discharged to the waters of the United States or a
municipal separate storm sewer system, you must practice good housekeeping and best
management practices to avoid unnecessary pollutant load to receiving waters. Your
Storm Water Pollution Prevention Plan (SWPPP) must identify on site map where these
allowable non-storm water discharge activities take place, anticipated pollutant that might
mix with the discharge, and appropriate best management practices being implemented.
NOT AUTHORIZED FOR COVERAGE UNDER the MSGP
The following are not authorized for coverage under the MSGP:
• Discharges mixed with non-storm water (non-storm water discharges)
• Discharges associated with construction activity. There is a Construction Storm
Water General Permit for any disturbance of land greater than 1 acre.
• Discharges currently or previously covered by another permit.
o covered under an individual permit
o has an expired permit
o permit contains no numeric water quality limitations for storm water
o a permit that is being denied, terminated or revoked
• Discharges subject to effluent limitation guidelines. Effluent guidelines are
national standards for waste water discharges (to surface waters and municipal
sewer treatment plants) and are based on the performance of treatment and control
technologies. Allowable under the MSGP are discharges from the following:
1. Sector E, runoff from material storage piles at cement manufacturing (*)
2. Sector C, runoff from phosphate fertilizer manufacturing (*)
3. Sector O, coal pile runoff at steam electric generating facilities (*)
4. Sector A, spry down or wetting of logs at wet deck storage areas (*)
-------
5. Sector J, mine dewatering discharges at crushed stone mines, construction
sand/gravel mines, industrial sand mines
6. Sector D, runoff from asphalt emulsion facilities (*)
7. Sector K & L, runoff from landfills (*)
• Discharges subject to New Source Performance Standards (NSPS). Identified
with (*) above. The New Source Performance Standards process requires the
EPA to list categories of stationary sources which "cause, or contribute
significantly to, air pollution which may reasonably be anticipated to endanger
public health or welfare." The term "New Source" is defined broadly to include
newly constructed factories or furnaces as well as any modification of existing
sources, including changes in the way sources are operated that increase
emissions or add a new pollutant to emissions.
o If you fall under one of the effluent limitation discharges that has NSPS
(*), you can apply for the industrial storm water permit (e.g. MSGP) as
long as you have documentation from EPA of "no significant impact" or a
completed Environmental Impact Statement under National
Environmental Policy Act (NEPA).
• Discharges that have the potential to contribute to water quality standard
violations. Water Quality Standards define the goals for a water body by
designating its uses (e.g. swimming, fishing, agricultural, industrial, etc), setting
criteria to protect those uses, and establishing provisions to protect water bodies
from pollutants.
o You may be eligible for an "individual" storm water permit. Or you may
be eligible for coverage under the MSGP if you can show you have
appropriate controls and procedures in place to prevent water quality
standard violations (documented in your SWPPP).
• Discharges that do not avoid unacceptable effects on federally listed endangered
and threatened species or designated critical habitat.
o You may be eligible for coverage under the MSGP if your activities are
not likely to jeopardize the continued existence of endangered species or
habitat. There's a long list of criteria in the MSGP that you' d need to
consult.
• Discharges with unconsidered adverse affects on historic properties. There are
several criteria in the MSGP to determine if you can be eligible for coverage.
• Discharges to water quality impaired or water quality limited receiving waters.
You are not authorized to discharge into waters that have Total Maximum Daily
Load (TMDL) established or approved by EPA unless your discharge is
consistent with the TMDL limits.
• Discharges to waters that have anti-degradation water quality standards. Anti-
degradation refers to water bodies that have unique attributes and/or has national
significance.
MSGP SECTORS THAT TYPICALLY MATCH A PORT FACILTIY: Sector C, D, E, F, K, N,
P, Q, R, U, Y, AB. Limitation on coverage fall under sectors C, D, K, N, P, Q, R, U.
PORT SECTOR LIMINATIONS ON COVERAGE IDENTIFIED IN THE MSGP
-------
The following port sectors have "limitations on coverage" identified in the MSGP. In
other words the emphasized non-storm water discharge is typical to the sector and that
the discharge most likely is covered under a separate permit, or should be. Separate
permit or not, the following discharges are not authorized for coverage under the MSGP.
If these discharges are identified, they must be eliminated or seek coverage under a
separate permit.
Sector C Chemical & Allied Products Manufacturing
• Non-storm water discharges containing inks, paints, or substances resulting from
an onsite spill, including materials collected in drip pans.
• Non-storm water discharges containing wash water from materials handling and
processing areas.
• Non-storm water discharges containing wash water from drum, tank or container
rinsing and cleaning.
Sector D Asphalt Paving & Roofing Materials & Lubricant Manufacturers
• Non-storm water discharges from petroleum refining facilities, including those
that manufacture asphalt or asphalt products.
• Non-storm water discharges from oil recycling facilities.
• Non-storm water discharges associated with fats and oils rendering.
Sector K Hazardous Waste Treatment, Storage or Disposal
• Non-storm water discharges for facilities located in EPA Region 6 (i.e. NM, TX,
OK, AR, LA) that are self-generating or handle residential wastes only and to
those facilities that only store hazardous wastes and do not treat or dispose.
Coverage under this MSGP is not available for commercial hazardous waste
disposal/treatment facilities that dispose and treat on a commercial basis any
produced hazardous wastes as a service to generators.
• For all other facilities outside of EPA Region 6, non-storm water discharges
containing leachate, gas collection condensate, drained free liquids, contaminated
ground water, laboratory-derived waste water, contact wash water from washing
truck and rail car exteriors, and surface areas which have come in direct contact
with solid waste at the landfill facility.
Sector N Scrap Recycling & Waste Recycling Facilities
• Non-storm water discharge from turnings containment areas are not covered by
this permit. Discharges from containment areas in the absence of a storm event
are prohibited unless covered by a separate NPDES permit.
Sector P Land Transportation
• Non-storm water discharge containing vehicle/equipment/surface washwater,
including tank cleaning operations. Such discharges must be authorized under a
separate NPDES permit, discharged to a sanitary sewer in accordance with
applicable industrial pretreatment requirements, or recycled on-site.
Sector Q Water Transportation
• Non-storm water discharges containing bilge and ballast water, sanitary wastes,
pressure wash water, cooling water originating from vessels (same as Sector R).
Sector R Ship & Boat Building or Repair Yards
• Non-storm water discharges containing bilge and ballast water, sanitary wastes,
pressure wash water, cooling water originating from vessels (same as Sector Q).
-------
Sector U Food & Kindred Products
• Non-storm water discharge from the eleven (11) allowable non-storm water
discharges that are associated with industrial plant yards and material handling
sites including discharges containing boiler blowdown, cooling tower overflow
and blowdown, ammonia refrigeration purging and vehicle washing/clean-out
operations.
• Non-storm water discharge associated with refuse sites.
• Non-storm water discharge associated with sites used for application or disposal
of process waste waters.
• Non-storm water discharge associated with sites used for storage and maintenance
of material handling equipment.
• Non-storm water discharge associated sites used for residential waste water
treatment, storage, or disposal.
• Non-storm water discharge associated shipping and receiving areas.
• Non-storm water discharge associated manufacturing buildings.
• Non-storm water discharge associated storage areas for raw material and
intermediate and finished products, including areas where industrial activity has
taken place in the past and significant materials remain.
PORT SECTOR NO LIMITATIONS ON COVERAGE
The MSGP does not have a section titled "limitations on coverage" for the following
sectors:
Sector E Glass, Clay, Cement Concrete, & Gypsum Products and
Sector F Primary Metals and
Sector Y Rubber, Miscellaneous Plastic Products & Miscellaneous
Manufacturing Industries and
Sector AB Transportation
Even though the MSGP does not specifically list limitations on coverage for the above
sectors, the sector is not allowed to discharge non-storm water discharges. The MSGP
basically says that no facility is allowed non-storm water discharges unless the permit
explicitly authorizes them/it. And that all allowable non-storm water discharges must be
identified in the SWPPP. The eleven (11) allowable non-storm water discharges are
listed above.
------- |