A  Citizen's  Guide  to
Vertical   "
What Are Vertical Engineered Barriers?

A vertical engineered barrier, or "VEB," is a wall built
below ground to control the flow of groundwater. VEBs
may be used to divert the direction of contaminated
groundwater flow to keep it from reaching drinking water
wells, wetlands, or streams. They also may be used to
contain and isolate contaminated soil and groundwater
to keep them from mixing  with clean  groundwater.
VEBs differ from permeable  reactive barriers in that
they do not clean up contaminated groundwater. (See
A Citizens Guide to Permeable Reactive Barriers [EPA
542-F-12-015].)  However, cleanup methods  often  are
used together with VEBs to treat the isolated soil or
groundwater.

How Do They Work?

VEBs are made of impermeable or slightly permeable
materials,  which  means  they  prevent  or  minimize
the flow of water and  contaminants through the wall.
A slurry wall is the most common type  of VEB. It is
constructed by digging a  narrow trench, usually 2 to 4
feet wide with a backhoe  or long-reach excavator. The
trench is filled with slurry, which consists of soil mixed
with water and clay. A type of clay called  "bentonite" is
used most often because it expands when  wet to fill
  Monitoring Well
Illustration of a VEB containment system around a contaminated area
gaps or holes in the VEB. Cement may be added to
make the slurry wall stronger.

A VEB also can be constructed using sheet pilings
made of steel, vinyl, or other materials. Sheet pilings
are large sheets linked together at their edges to form
a wall. Equipment is used to  hammer or vibrate the
sheets into the ground.

Where possible, the  bottom  of the VEB is  "keyed
into"  a low-permeability layer of soil or bedrock. This
means the bottom of the wall  extends several inches
into the soil or to the top of the bedrock, which helps
to keep groundwater from seeping beneath the wall. A
protective cap may be installed atop the VEB to prevent
damage from vehicle traffic or other activities. A larger
impermeable cap often  is placed over the entire
contaminated area enclosed by the VEB to prevent rain
water and snow melt from entering it. (See A Citizen's
Guide to Capping [EPA 542-F-12-004].)

Even when surrounded by a VEB and cap, contaminated
groundwater may build up in the isolated area or move
outward through small openings in the  VEB  toward
clean areas.  To prevent this, wells may be drilled
within the isolated area to pump out groundwater.
Contaminated  groundwater that has been pumped to
the ground surface usually will  require treatment.

The VEB, cap, and pumping wells are maintained and
monitored to  ensure the  contaminated area remains
isolated and that contaminated groundwater does not
spread to  clean areas.

How Long Will It Take?

Building a VEB may take anywhere from several days
to several months.  Construction of a  VEB may take
longer where:

  •  The contaminated area is large or deep.

  •  Soil is hard or rocky.

  •  The VEB is wide.

These factors vary from site to site. Some VEBs may
stay in place permanently.

-------
Are Vertical Engineered Barriers Safe?

The materials used to construct a VEB generally pose little risk to people or the
environment. VEBs are effective at keeping contaminated  groundwater from
flowing toward clean areas. A VEB will continue to be protective as long as it is
properly inspected and maintained. VEBs and the groundwater are monitored
to make sure that there is no damage  to the wall and contaminants are not
moving to other areas.

How Might It Affect Me?

Residents near the site may see increased truck traffic as materials are brought
to the site. Construction of  the VEB may involve backhoes, pile drivers, or
other noisy machines.  If sheet pilings are hammered or vibrated into  place,
nearby residents also may feel the vibrations. If buildings or people are nearby,
monitoring can be conducted to  make sure noise and vibration levels do not
exceed  limits. Workers often use  equipment that cause  as little noise  and
vibration as possible. Workers will need to access the area for VEB maintenance
and repairs or to collect groundwater samples to ensure the VEB is working. At
sites where groundwater is being removed and treated, workers may be present
for longer periods of time.

Why Use Vertical Engineered Barriers?

VEBs may be selected at sites where cleanup of contaminated groundwater
is difficult and  expensive,  or cannot  be  completed  before contamination
spreads to areas where people and wildlife can come in contact with it. VEBs
are also helpful in cases where cleanup methods could push contaminants to
uncontaminated areas. VEBs typically are less expensive to build and maintain
than other types of technologies, especially in large contaminated areas. VEBs
have  been selected or are being used at dozens Superfund sites across the
United States.
Installation of sheet piling
Excavation of a slurry wall trench
                                      	Example
                                      Spills of wood-treating
                                      chemicals contaminated the soil
                                      and groundwater at the Taylor
                                      Lumber and Treating Superfund
                                      site in Oregon. A 2,040-foot
                                      long, 21/2-foot wide, VEB
                                      was constructed of bentonite
                                      and soil to isolate a plume of
                                      contaminated groundwater. The
                                      VEB encloses a 6-acre area
                                      and extends 14 to 16 feet below
                                      ground where it is keyed into
                                      bedrock. A protective asphalt
                                      cap installed over the VEB and
                                      contaminated area protect the
                                      VEB from heavy equipment
                                      traffic and prevent rainwater
                                      from soaking into the area it
                                      encloses.

                                      As part of the long-term
                                      operation and maintenance
                                      of the VEB, groundwater is
                                      pumped from four wells in the
                                      contaminated area to keep
                                      contaminants and groundwater
                                      from seeping outside the wall.
                                      Groundwater outside the VEB
                                      is regularly sampled to make
                                      sure contaminants remain in the
                                      enclosed area and do not pose
                                      a threat to human health or the
                                      environment.

                                       For More Information
For more  information on this
and other  technologies in  the
Citizen's Guide Series, contact:
          U.S. EPA
   Technology Innovation &
    Field Services Division
 Technology Assessment Branch
       (703)603-9910
NOTE: This fact sheet is intended solely as general information to the public. It is not intended, nor can it be relied upon, to create any
rights enforceable by any party in litigation with the United States, or to endorse the use of products or services provided by specific
vendors. The Agency also reserves the right to change this fact sheet at any time without public notice.
United States
Environmental Protection
Agency
Office of Solid Waste and
Emergency Response
(5102G)
EPA 542-F-12-022
September 2012
www.epa.gov/superfund/sites
www.cluin.org

-------