Errata Sheet: Wet and Dry Scrubbers Cost Calculation Spreadsheet (January 2023)

The US EPA notes that the following corrections have been made in the wet flue gas
desulfurization (WFGD) Cost Estimate tab of this cost calculation spreadsheet:

In cell C76 in the WFGD Cost Estimate tab, change "SDA" to "WFGD."

In cell B84 in the WFGD Cost Estimate tab, change "SDA" to "WFGD."

In cell G18 in the WFGD Cost Estimate tab, change "SDA" to "WFGD."

In addition, the capital recovery factor (CRF) formulas in the whole of this spreadsheet now has
parentheses enclosing the whole of the denominator. Estimates of the CRF are not changed by
this addition, but it clarifies the format of the formulas.

The US EPA notes that the following corrections and clarifications have been made in the
packed bed scrubber tabs of this cost calculation spreadsheet:

Tab: PB Scrubber Data Inputs

1)	Correct spelling of "concentration" in cell B7

2)	Correct spelling of "minimum" in cell B17

Tab: PB Scrubber Design Parameters

3)	Added "actual" subscript to cell B18 to clarify that Ls/Gs actual, not minimum,
should be used

4)	Corrected a typo in cell A13 ("ratio" not "ration").

5)	Changed "Xo" to "Xout" and "Xi" to "Xin" in cell A22 for clarity

6)	Corrected equation in cell C22 to be (yout* - yin*)/(xout - xin) instead of
(Yout*/xout) [note lower and upper case letters)

7)	Cell A45 is "Lin" (the solvent flow rate) but the equation to estimate this value also
uses "Lin". Have replaced Lin with(L sft,in)min, the superficial liquid flow rate.

8)	Cell B51 should be "stainless" not "tainless".

9)	Cell C50 (HCI removed per year) has been corrected to (Gmass,p x top )/2000 x
(Removal efficiency)/100). In addition, the calculation for this cell is now in tons per
year, not pounds per hour.

10)	Clarified in cell C52 that 390.6 is the CEPCI for 1991.

11)	Cell C72 (Sorbent consumption rate (Qsorbent)) has been corrected to 0.5 moles of
sorbent x Gmass,p x MWs x (Removal efficiency (r|)/100).

Tab: PB Scrubber Cost Estimate

1)	Have deleted duplicate word in cell A38.

2)	Have corrected spelling of "maintenance" in cell A57.

3)	Have corrected reference in cell C68 to the CFR in the "PB Scrubber Design
Parameters" tab instead of linking to the CFR in the "SDA Design Parameters" tab.

1


-------